five. In step 14, when putting in the tracks (DD) to your wood blocks (R), contain the wood block stick out close to an inch past the edge with the tracks with the aspect that should attach to the end piece (K and the rest). Another two blocks need to be flush with the end of your tracks that connect to the cabinet piece.With many motion, several o
five. In move 14, when installing the tracks (DD) into the wood blocks (R), contain the wood block adhere out approximately an inch past the sting on the tracks for your aspect which will connect to the end piece (K and The remainder). The opposite two blocks really should be flush with the end on the tracks that connect to The cupboard piece.I man
I really like the concept on the table. I'd a few selections picked out but decided to go with this a person even though it was two hundred.00 over the other brand. I'm really kicking myself as everyone who left an evaluation said how the directions have been terrible. My husband who is extremely helpful experienced a considerable problem. I come t
I made them all flush to start with which triggered the tracks to not be lengthy sufficient, Therefore the 3rd leaf overlapped the sting with the table by about 1 centimeter. Leaving that further inch (from the block sticking earlier the tracks) will allow you to adequately lengthen the table, increase the 3rd leaf, then drive the table shut right
five. In move 14, when installing the tracks (DD) to your wood blocks (R), possess the wood block adhere out somewhere around an inch earlier the sting from the tracks to the side that could attach to the tip piece (K and The remainder). Another two blocks should be flush with the top of the tracks that connect to the cabinet piece.Your not long ag